Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
help finding an uninterruptible power supply
#11
> I've seen UPSs blown by high draw hardware such as laser printers.
I've seen light bulb blow when powered on. That proves power cycling damaged light bulbs. I've seen the lake fill with water. The be filled with larva. That proves spontaneious reproduction. I've seen moldly bread breed maggots. That proves that maggots are spawned by moldy bread.

In every case, junk science. Because the conclusion comes only from observation.

Conclusions must come first from hard facts. A UPS is often made so cheaply as to be missing necessary functions including overcurrent protection. Other reasons could also explain that damage. But without knowing specifically what was damaged, then any conclusion from observation can only be wild speculation.

Bottom line fact remains. Power from a UPS in battery backup mode is often some of the 'dirtiest' power seen by an appliance. Due to superior protection already inside electronics, that 'dirtiest' power is sufficient or ideal. A need for "pure sine waves" to protect hardware is a popular myth.

Without knowing what was damaged or why, the observation is only speculation. Meanwhile, the observation does not change a reality. "Dirtiest' power from any UPS does not harm electronic hardware.

A UPS is temporary and 'dirty' power during a blackout. Blackouts do not danage electronics hardware. 'Dirty' UPS power does not do hardware damage. Other anomalies that can damage hardware require other solutions. But first that anomaly must be defined.
Reply
#12
Westom,

Feel free to disagree with me and/or come to your own conclusions. As I said, I've experienced first hand a blown UPS due to someone connecting a laser printer to it. The source of the damage was confirmed by the manufacturer of the UPS. That's assessment is good enough for me. Same goes for what I've been told by UPS and hardware manufacturers about the type of power preferred by electronics such as computers.

Robert
Reply
#13
Robert M wrote:
As I said, I've experienced first hand a blown UPS due to someone connecting a laser printer to it.
Irrelevant to the OP and topic is why your one UPS was failed. Relevant is this discussion are bottom line facts.

1) A UPS in battery backup mode is typically some of the 'dirtiest' power.

2) Due to superior protection already inside electonics, that 'dirty' powre is also sufficient or ideal for electronics.

3) The OP must define what electrical anomaly should be solved. A UPS does not protect hardware. But other solutons (such as cited by Bill in NC) does protect hardware from specific anomalies.

What happened to your UPS is irrelevant. Reepearing but again what is relevant. OP asked about, "to save potential loss of equipment ". Dirty power from a UPS does not do and does not claim to do hardware protection. Other solutions (such as provided by Bill in NC) do hardware protection.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)