Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
EcoBee SmartSensor 2-Pack Deal $20 off, ends 12/3.
#1
I have never seen these on sale before.

EcoBee wrote:
Works with SmartThermostat with voice control, ecobee4, ecobee3 lite, and ecobee3.

https://www.ecobee.com/en-us/smart-sensor/

Deal ends tomorrow.
Reply
#2
the sensors did go on sale last year at this time which is when i picked up a set. better deal last year. 50% off. but since the sensors never seem to go onsale otherwise it's a good deal.
Reply
#3
I suppose the deal is on new sensors that are somehow better, so maybe the price difference is justified?
Reply
#4
Their site says:

Improved sensor technology

Now with better range and accuracy, and up to five years of battery life.


That may be worth something, especially if someone got a Lite kit with one or two less sensors?
Reply
#5
Time for me to google if there is some way to get my proprietary Carrier system working with a Nest/Ecobee.

And again, time to be disappointed.
Reply
#6
Lux Interior wrote:
Time for me to google if there is some way to get my proprietary Carrier system working with a Nest/Ecobee.

And again, time to be disappointed.

It should be possible. The Ecobee installation instructions I had were manufacturer agnostic. I just had to connect their adapter to the wiring inside the AC/furnace because (if I recall correctly) it did not have a "B-wire" running up to the thermostat location.
Reply
#7
mikebw wrote:
[quote=Lux Interior]
Time for me to google if there is some way to get my proprietary Carrier system working with a Nest/Ecobee.

And again, time to be disappointed.

It should be possible. The Ecobee installation instructions I had were manufacturer agnostic. I just had to connect their adapter to the wiring inside the AC/furnace because (if I recall correctly) it did not have a "B-wire" running up to the thermostat location.
I have a proprietary "communicating" thermostat.

I may be able to rewire directly from the EIM, but I haven't looked into it yet.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)