MacResource › My Category › Tips and Deals v
carpentry (kind of ) question

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
carpentry (kind of ) question
rgG Online
Thankful to be here
*****
Posts: 31,136
Threads: 1,758
Joined: May 2025
Reputation: 8
#2
04-14-2010, 01:43 PM
If you take the plate off, could you cut a small block to fit the size of the hole where the bolt goes, then glue that in with wood glue and sand it flush? That should give you a fairly clean slate to work with when you chisel out a new hole for the strike plate.
[Image: IMG-2569.jpg]
Whippet, Whippet Good
Find
Reply


Messages In This Thread
carpentry (kind of ) question - by Fritz - 04-14-2010, 01:35 PM
Re: carpentry (kind of ) question - by rgG - 04-14-2010, 01:43 PM
Re: carpentry (kind of ) question - by StingMe - 04-14-2010, 01:47 PM
Re: carpentry (kind of ) question - by Fritz - 04-14-2010, 01:47 PM
Re: carpentry (kind of ) question - by billb - 04-14-2010, 02:16 PM
Re: carpentry (kind of ) question - by lafinfil - 04-14-2010, 02:20 PM
Re: carpentry (kind of ) question - by tenders - 04-14-2010, 02:48 PM
Re: carpentry (kind of ) question - by lafinfil - 04-14-2010, 03:04 PM
Re: carpentry (kind of ) question - by billb - 04-14-2010, 03:22 PM
Re: carpentry (kind of ) question - by MikeF - 04-14-2010, 04:11 PM
Re: carpentry (kind of ) question - by Ken Sp. - 04-14-2010, 05:16 PM
Re: carpentry (kind of ) question - by Fritz - 04-14-2010, 09:40 PM
Re: carpentry (kind of ) question - by Racer X - 04-14-2010, 09:49 PM
Re: carpentry (kind of ) question - by RE:up - 04-14-2010, 11:25 PM
Re: carpentry (kind of ) question - by Fritz - 04-15-2010, 12:04 AM
Re: carpentry (kind of ) question - by rgG - 04-15-2010, 01:46 AM
Re: carpentry (kind of ) question - by Fritz - 04-16-2010, 02:26 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)