06-06-2011, 01:33 PM
when I was a kid I used to attend an Electronics club where we would make Printed Ciruit Boards using some special ink or sometimes a fine marker (but that didn't always work very well) and then etching the Copper in an acid bath.
I would like to make a few simple PCB boards sometime in the future (no immediate plans) and I wonder what is the best method these days.
Or is there an online shop that will make custom PCBs for a very reasonable charge? I don't need anything fancy, just 2 sided, maybe 4"x6" at most. It would be very nice if they would also drill them.
Thanks
I would like to make a few simple PCB boards sometime in the future (no immediate plans) and I wonder what is the best method these days.
Or is there an online shop that will make custom PCBs for a very reasonable charge? I don't need anything fancy, just 2 sided, maybe 4"x6" at most. It would be very nice if they would also drill them.
Thanks