06-07-2020, 06:12 PM
What everybody else said...
If you already have clamps then using a 1x4 or 2x4 would be fine. But, if you have to buy clamps, you might buy this instead:
https://www.harborfreight.com/hand-tools...66581.html
If you have a Harbor Freight near you, of course. The 20% coupons that are all over the place would make it cost a bit over $18. I find it easier to make a square cut with it rather than 2 clamps and a board.
If you already have clamps then using a 1x4 or 2x4 would be fine. But, if you have to buy clamps, you might buy this instead:
https://www.harborfreight.com/hand-tools...66581.html
If you have a Harbor Freight near you, of course. The 20% coupons that are all over the place would make it cost a bit over $18. I find it easier to make a square cut with it rather than 2 clamps and a board.