Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Final Cut Studio 2 on 1Ghz 17" PowerBook w/1GB RAM
#1
It installs...works. Original, 1st gen 17"

As in the past, the installation (or components of) wouldn't even take place if the machine did not meet the requirements. The installation does prompt that is recommended to be installed on a 1.25Ghz+ (along with video card specification)...but afterwards, does allow the full install - including Motion - surprisingly.

Just wanted to pass it along.

This will be going on more robust workstations...but pulled out an old laptop for grins.
Reply


Messages In This Thread
Final Cut Studio 2 on 1Ghz 17" PowerBook w/1GB RAM - by onthedownlow - 05-23-2007, 06:29 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)