Making a Franken-G3 iMac... swap Mobo, or PAV Board?

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

Making a Franken-G3 iMac... swap Mobo, or PAV Board?

The Grim Ninja Offline

Offline

Unregistered

Posts: 2,502
Threads: 118
Joined: May 2025

#5

08-24-2006, 06:48 PM

The slot load iMacs are all interchangeable. The processors use a whole-case heatsink. (ie, the heatsink is the entire case chassis, just bolts right up against it). If you had a 350 system, you'd need to swap the port cover too, since they didn't have firewire ports.

Find

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Making a Franken-G3 iMac... swap Mobo, or PAV Board? - by Paul F. - 08-24-2006, 05:00 PM

Re: Making a Franken-G3 iMac... swap Mobo, or PAV Board? - by Paul F. - 08-24-2006, 05:06 PM

Re: Making a Franken-G3 iMac... swap Mobo, or PAV Board? - by C(-)ris - 08-24-2006, 05:23 PM

Re: Making a Franken-G3 iMac... swap Mobo, or PAV Board? - by incognegro - 08-24-2006, 05:48 PM

Re: Making a Franken-G3 iMac... swap Mobo, or PAV Board? - by The Grim Ninja - 08-24-2006, 06:48 PM

Re: Making a Franken-G3 iMac... swap Mobo, or PAV Board? - by Paul F. - 08-24-2006, 07:11 PM

Re: Making a Franken-G3 iMac... swap Mobo, or PAV Board? - by Racer X - 08-24-2006, 09:19 PM

Re: Making a Franken-G3 iMac... swap Mobo, or PAV Board? - by mikebw - 08-25-2006, 09:30 AM

View a Printable Version

Users browsing this thread: 1 Guest(s)