05-03-2007, 10:22 AM
Well it's really not just the number of devices, but the total amps that they are drawing at any given time. If you are exceeding the limit for the circuit it would trip the breaker.
How many outlets are you using? Most regular outlets are rated for 15A. Divide your higher load devices between separate outlets if possible.
Make sure your extension cords are good thick gauge ones capable of supporting 15A loads. Same goes for the power strips. Thinner extensions and power strips will actually increase the load on the outlet because they will heat up under high loads, increasing resistance in the wire. UPS's draw power too. If you don't need them don't use them.
If you've got an outlet on the other side of the wall (from a different circuit) then you've pretty much got an outlet in your current room. All it would take is switching the box around inside the wall and moving the faceplate. Maybe not as easy a punching a hole in the wall, but if you're going to bust stuff up anyway at least this would be to code.
How many outlets are you using? Most regular outlets are rated for 15A. Divide your higher load devices between separate outlets if possible.
Make sure your extension cords are good thick gauge ones capable of supporting 15A loads. Same goes for the power strips. Thinner extensions and power strips will actually increase the load on the outlet because they will heat up under high loads, increasing resistance in the wire. UPS's draw power too. If you don't need them don't use them.
If you've got an outlet on the other side of the wall (from a different circuit) then you've pretty much got an outlet in your current room. All it would take is switching the box around inside the wall and moving the faceplate. Maybe not as easy a punching a hole in the wall, but if you're going to bust stuff up anyway at least this would be to code.