08-23-2008, 08:40 PM
Run a box cutter along the wall and baseboard to keep from pulling up the wall paint and caulk. I have seen it done both ways. I prefer to remove the baseboard very carefully if you want to reuse it. When the baseboard is removed, it is easier to sand and repaint before you replace it. Just remember to number each piece of baseboard section before you remove it to make sure you put it back in the right place. Also, consider going to a home improvement store and make sure they carry your specific baseboard.
Removing the baseboard makes more work, but it looks better in the end.
I would also recommend a brad nailer to drive in the baseboards.
Top info is from work I did on my old house and current work on my new place.
Another reason to remove the baseboards is that not all of your cuts are going to be perfect, so the imperfect cuts can be hid behind the baseboard.
Joe
Removing the baseboard makes more work, but it looks better in the end.
I would also recommend a brad nailer to drive in the baseboards.
Top info is from work I did on my old house and current work on my new place.
Another reason to remove the baseboards is that not all of your cuts are going to be perfect, so the imperfect cuts can be hid behind the baseboard.
Joe