12-29-2008, 11:09 PM
pictorially, because I am a losuy typer:
If you get the compression ring (the turny part) up on the upper pipe held in place on the upper pipe by the internal clear washer (pay attention to angles of clear washer when you take it apart) , those two should stay in place by the washer. (like in the pic)I've seen a couple rings that are bigger than the washer and you can't duplicate what you see in the pic. You'll need a third hand or some tape to hold it up.
If you get the compression ring (the turny part) up on the upper pipe held in place on the upper pipe by the internal clear washer (pay attention to angles of clear washer when you take it apart) , those two should stay in place by the washer. (like in the pic)I've seen a couple rings that are bigger than the washer and you can't duplicate what you see in the pic. You'll need a third hand or some tape to hold it up.