Posts: 24,926
Threads: 4,391
Joined: Nov 2024
Reputation:
0
The house was built in 1973 and the head carpenter died before it was finished, so there are lots of loose ends. I was hanging a new flourescent light and noticed the cut off wires in a few places just sticking out in space. There is little chance of them shocking someone; you would have to be on a ladder and reach above your head to touch them. And, they may not even be hot. But, it should be an easy job to terminate them properly and it's on my mind, that's going to be a project. Is the a gizmo you attach to the ends or some other way?
Posts: 31,030
Threads: 2,688
Joined: May 2025
What cbelt wrote! Never put an open fist over a wire to test (never do that in general but still).
Posts: 351
Threads: 15
Joined: May 2025
Reputation:
0
[Plastic or metal box?]
Probably either one will do. What ever you use should have a cover and clamps for the wire going into it.
Posts: 15,843
Threads: 95
Joined: May 2025
Dennis S wrote:
Plastic or metal box?
Either if that is okay with local code. Otherwise use the type required by code in your area.
Posts: 37,098
Threads: 2,599
Joined: May 2025
Reputation:
0
It’s been fine for 46 years, why change now?
Posts: 31,861
Threads: 708
Joined: Jun 2024
Reputation:
0
Yeah, terminate in a box and hopefully note where it ended.
If the wires are dead: clip off any stripped ends, spiral wrap a double layer of electrical tape over the last 2 inches, bend an inch back on itself and wrap again, tuck in box and close.
Posts: 37,098
Threads: 2,599
Joined: May 2025
Reputation:
0
IMO - if you see a reason for the run, just terminate as others have stated. Otherwise remove it.
Posts: 6,024
Threads: 68
Joined: May 2025
Reputation:
0
We had a couple of runs of 12-3 wire put into our house from the 2nd story attic down to the basement when we built. They are curled at the ends and labelled, although the label is getting very faint. We did it just in case we needed an extra circuit up there. Perhaps these are the same?
