source for aluminum extrusions for foamboard displays?

[artie67]

Been buying from Outwater Plastics for toooo many years. Their catalog is online. Phone book size and on my top shelf. Good service and ship from east and west coasts.

[Lizabeth]

jdc wrote:
Im with the make your own.

Use gator board -- looks like foam core but 3X as rigid.

Keep in mind that gator board is 3x harder to cut...

[bazookaman]

Lizabeth wrote:
[quote=jdc]
Im with the make your own.

Use gator board -- looks like foam core but 3X as rigid.

Keep in mind that gator board is 3x harder to cut...
We got some .25" corrugated plastic to do some prototyping. Talk about hard to cut. We ended up using a table saw. Like cutting hot butter.

[Mr Downtown]

Can one of you with the Outwater catalog tell me what page to look on for the extrusions? I seem to find everything but.

I'm still scratching my head at the suggestion that I somehow make my own.

[Z]

Mr Downtown wrote:
Can one of you with the Outwater catalog tell me what page to look on for the extrusions? I seem to find everything but.

I'm still scratching my head at the suggestion that I somehow make my own.

When I suggested you make your own, I was thinking discs rather than fully extruded rods - imagine your picture about 0.25" thick.

[Robert M]

MrD,

Check out places like this:



Robert

[CW2V]

Mr Downtown wrote:
Can one of you with the Outwater catalog tell me what page to look on for the extrusions? I seem to find everything but.

I'm still scratching my head at the suggestion that I somehow make my own.

Try starting here:

master catalog

There's more info here, but you may need to call to get more Foga info.

CW2V