11-16-2010, 06:24 AM
I had tried the method below before, but I think I did it wrong. I made sure to follow it perfectly this time and the blue light stays on and there is no toner light on. It is storming now so I can't try a print job until morning, but it looks good so far. Thanks for the help.
_______________________
From the link:
\\The following method below worked for HL-2140. THANKS! I routinely check my levels myself and am using a starter cartridge on 3rd refill. Still looks great and have not bought flag gear. I needed a way to use my printer without buying a new cartridge (yet)and this worked for me.
1. Open the front cover and leave open while completing the following steps.
2. Turn the printer off.
3. Hold the 'go' button while turning the printer on. All panel lights should be on.
4. Release the 'go' button.
5. Press the 'go' button 2 times.
6. Pause.
7. Press the 'go' button 5 times.
8. The toner light should be off.
9. The paper light should be on or flashing.
10. Close cover. The ready light should be the only light on.
_______________________
From the link:
\\The following method below worked for HL-2140. THANKS! I routinely check my levels myself and am using a starter cartridge on 3rd refill. Still looks great and have not bought flag gear. I needed a way to use my printer without buying a new cartridge (yet)and this worked for me.
1. Open the front cover and leave open while completing the following steps.
2. Turn the printer off.
3. Hold the 'go' button while turning the printer on. All panel lights should be on.
4. Release the 'go' button.
5. Press the 'go' button 2 times.
6. Pause.
7. Press the 'go' button 5 times.
8. The toner light should be off.
9. The paper light should be on or flashing.
10. Close cover. The ready light should be the only light on.