05-17-2014, 11:28 AM
WHiiP wrote:
The above information may be incorrect, as O continue to read what OWC has posted online. It does not appear to have any info regarding the PATA Mercury Elite Pro dual drive case. My bad.
In examining my unit I see no jumpers.
I will continue to look.
I opened up my enclosure last night to see whether it was SATA or PATA, as I couldn't remember. Turns out to be SATA. Someone, possibly the previous owner, had hand-written a jumper diagram on the inside of the case, and a note about where to find the jumpers. Without it, I'd have had no clue. I did look around a bit at OWC, but couldn't find info on the older enclosure.
The jumpers in the enclosure I have are at the very back of the bridge board on the right, not visible unless you disconnect the rear SATA cable. Not sure where they would be on a PATA case, though.
Good news if it can do JBOD. I may actually find a use for it if that is true. I think I bought it just wanting an enclosure that could hold more than one drive.