08-25-2006, 04:02 PM
Yeah, I'm sure a new printer would work fine, but considering I just bought ink for this one and would like to use it an addition to a new printer, it's not quite what I'm going for.
This printer was $180 when I bought it, so I'm wanting to get a bit more use out of it before its retired. Just trying to figure out the best way to overcome the rollers issue. (I'm considering taking it to my belt sander so there isn't so much plastic that has to fit through the rollers..)
This printer was $180 when I bought it, so I'm wanting to get a bit more use out of it before its retired. Just trying to figure out the best way to overcome the rollers issue. (I'm considering taking it to my belt sander so there isn't so much plastic that has to fit through the rollers..)